need advice on what EPOXY to use to seal back pealed rubber button on SB-600

[noruazumi]

hi guys...
those who have SB-600 u know there a rubber button to adjust tilt/rotate of the flash on the side right?
mine is pealed off, i meant almost peal off.
so i went to stationary store to look for some glue.
but i'm not sure which one to use. i'm afraid glue will damage the plastic and rubber.
so if you have any recommendation on which EPOXY/GLUE to use, please let me know.
i would appreciate a lot! thanks in advance.

[red]

i just use the 'dunlop' rubber glue...works fine....cheap too...
http://www.eagleasia.com/images/default/Products/6/417/ACF293.jpg

lots of left overs, i'm even repairing my slippers and sandals...hehehe...:cool:

[galee]

i just use the 'dunlop' rubber glue...works fine....cheap too...
http://www.eagleasia.com/images/default/Products/6/417/ACF293.jpg

lots of left overs, i'm even repairing my slippers and sandals...hehehe...:cool:


Yeah~~ that is one good glue... multi-purpose... I used it to glue my shoes, Buttons on most of my remote control and even saw some kids smelling them at roadside~! Simply remarkable... :)

[noruazumi]

i just use the 'dunlop' rubber glue...works fine....cheap too...
lots of left overs, i'm even repairing my slippers and sandals...hehehe...:cool:

Yeah~~ that is one good glue... multi-purpose... I used it to glue my shoes, Buttons on most of my remote control and even saw some kids smelling them at roadside~! Simply remarkable... :)

thanks guys! never thought of it! :D
off to hardware store!

[galee]

Noru,

Before you apply the glue, have u asked NSC wether they can replace the button for you? At times, they will change one for you FOC... Worth asking b4 applying the sticky stuff on it. :D

[noruazumi]

Noru,

Before you apply the glue, have u asked NSC wether they can replace the button for you? At times, they will change one for you FOC... Worth asking b4 applying the sticky stuff on it. :D

i did thought of sending it to Nikon with the hope that they might replace it for free or for a minimum charge. but need to send it all the way to PJ while i'm in Penang. adoi.... :(

[Jamal Rahman]

That 'rubber glue' will do just fine. Happened to my SB600 once.