PDA

View Full Version : blur, & W/B out


edwintcg
05-25-2007, 06:54 PM
anyone can help?
2018

edwintcg
05-25-2007, 06:58 PM
i think i over PP this one:

ShaolinTiger
05-25-2007, 07:10 PM
Here's my effort, was tough to fix the strong yellow cast again.

2020

Remember shoot in RAW, and WB is important!

artyeo
05-25-2007, 08:20 PM
my try ..

2021

sharontansw
05-25-2007, 10:24 PM
my try :)

oops! forgotten how i did it.. never write down the step... did on a few layers.... used.....
~ image - adjustment - photo filter, selective color, hue/saturation, brightness/contrast
~ layer - soft light
~ filter - blur - gaussian blur

edwintcg
05-25-2007, 11:18 PM
wah, thanks for all. Sharon, i read your post before, nice work.. mind to crack a bit and let me know the steps? plsssssss

sharontansw
05-26-2007, 12:06 AM
wah, thanks for all. Sharon, i read your post before, nice work.. mind to crack a bit and let me know the steps? plsssssss

thanx.. i'm really sorry as all my editing work was trial & error methods.. i would love to share but i really can't recall how i did the above pix.. but most of the time.. when the photo is too yellowish i will used the cooling filter to tone down the yellow then adjust the brightness

i'm also still learning PS & been practising quite a number over here recently.. especially this week :D :D

tips.. for newbie using PS my advise is.. duplicate a layer.. work on layer by layer.. eg. 1st layer adjust the color until u satisfied then duplicated the layer to adjust the brightness then another if needed

my way of editing might be wrong.. but this is how i do.. i'm just a self learner.. i hope this help

oh.. i am not a good writer.. i hope u can understand what written above :)

blur
05-26-2007, 11:35 AM
This is my try! Trial and error ...

2039

1. Color Balance
2. Hue/Saturation
3. Duplicate the layer, desaturate it and change layer mode to Screen.
4. Adjust the curves of the desaturated layer to get a low-key/dark image.
5. Add a layer mask to the desaturated layer, and mask out the background.
6. Merge colour and desaturated layers together, adjust the levels and apply USM.

I used GIMP therefore I didn't give the exact values I used and I hope my "general" explanations will help.

leschang
06-01-2007, 07:30 PM
my try, colour adjustment, USM, skin retouching and put on lipstick. :D