g88
11-16-2007, 01:47 PM
Campro variable intake module production-ready
"The Intake Air Fuel Modulefor the Proton Campro engine is now ready, and is only awaiting Proton’s green light to begin production. This new IAFM is a basically a variable geometry intake system, developed under a joint fast track programme which began in April 2005 by EPMB, Bosch and Proton.
We first heard of it back in October 2006 where it was still in advanced tooling stages, and ever since then everyone has been eagerly awaiting for the first Campros to roll out with the new air fuel module. The IAFM varies intake manifold length to suit different engine conditions - a short runner length for high revs and a long and narrower runner length for low revs."
Full Article : http://paultan.org/archives/2007/11/14/campro-variable-intake-module-production-ready
"The Intake Air Fuel Modulefor the Proton Campro engine is now ready, and is only awaiting Proton’s green light to begin production. This new IAFM is a basically a variable geometry intake system, developed under a joint fast track programme which began in April 2005 by EPMB, Bosch and Proton.
We first heard of it back in October 2006 where it was still in advanced tooling stages, and ever since then everyone has been eagerly awaiting for the first Campros to roll out with the new air fuel module. The IAFM varies intake manifold length to suit different engine conditions - a short runner length for high revs and a long and narrower runner length for low revs."
Full Article : http://paultan.org/archives/2007/11/14/campro-variable-intake-module-production-ready